Loading ...
Loading ...
Important: after installation is completed, turn
on hot and cold water supplies. Check for leaks. Pull the
hose assembly out of the spout and remove the spray head
by unscrewing it from the hose counterclockwise. Be sure
to hold the end of the hose down into the sink and turn the
faucet on to the warm position where it mixes hot and cold
water. Flush water lines for one minute. Check for leaks.
Re-tighten any connections if necessary, but do not
overtighten. Reinstall spray head by hand tightening it back
onto the spray hose.
Make connections to water lines.
Use 1/2" I.P.S. faucet connections (1) or use coupling
nuts (3) with 3/8" O.D.ball-nose riser (2). Use
wrenches to tighten connections. Do not overtighten.
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
Screw quick connect assembly to the free end of pull-out hose.
Align male fitting (1) and tabs (2) on quick connector. Push
quick connector housing firmly upward and snap onto receiving
male fitting. Pull down moderately to ensure connection has
been made.
After connecting the hose, attach weights (3) to hose at bottom
of loop to prevent hose from twisting and return hose to proper
position.
STEPS:
1
2
3
3
1
2
Loading ...
Loading ...