Loading ...
Loading ...
Loading ...
10
Charging the Battery
1. Push the push lock button on the battery to pull the
battery pack out from the battery compartment (Fig. 1).
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
3. The battery will take approximately 4 – 5 hours to charge.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
mCAUTION! FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet rst, then disconnect the charger from the battery
mWARNING! This charger does not automatically turn o
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch o or unplug the
charger at the mains when charging is complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
Installing/Removing Air Hose
1. Remove the battery pack from the air compressor.
2. Insert the air hose connector into the open end of the air
compressor then tighten it by turning clockwise (Fig. 3).
3. To remove, turn the air hose connector counter-clockwise
and remove the air hose (Fig. 4).
Fig. 1
Push button
Fig. 2
Battery
indicators
Fig. 3
Air hose
connector
Fig. 4
Air hose
connector
Loading ...
Loading ...
Loading ...