Loading ...
Loading ...
Loading ...
31
EN
Wall Drilling and Bracket Fixing
As a rst step, proceed with the following drawings:
• A vertical line up to the ceiling or up to the upper limit, at the center of the area in
which the hood is to be tted.
(A) A horizontal line A at 1270–1560 mm above the cooker top.
(B) A horizontal line B at a minimum 887 mm (840 mm optional) above the cooker top.
(C) A horizontal line C at a minimum 717 mm above the cooker top.
Mark Points
Note: The specied values are [mm].
(1) Mark a point (1) on the horizontal line A, 40 mm to the right of the vertical
reference line. Repeat this step on the left side of the reference line and make sure
that the two points are at the same height.
(2) Mark a point (2) on the horizontal line B, 80 mm (135 mm oprtional) to the right
of the vertical reference line. Repeat this operation on the other side and on the
vertical reference line, checking that the three marks are leveled.
(3) Mark a point (3) on the horizontal line C, 112.5 mm to the right of the vertical
reference line. Repeat this operation on the other side, checking that the two marks
are on the same horizontal line.
Fix the brackets (optional)
• Drill at the marked points (1) (2) (3), using a10 mm drill bit.
• Insert the Wall Plugs into the holes (1) (2) (3).
• Fix the hood xing bracket with 3 screws (5 x 50) supplied with the hood.
• Fix a Chimney xing bracket with 2 screws (5 x 50) supplied with the hood.
Loading ...
Loading ...
Loading ...