Nissan ALTIMA 2021 SR FWD

User Manual - Page 489

For ALTIMA 2021 SR FWD.

PDF File Manual, 604 pages, Read Online | Download pdf file

ALTIMA 2021 SR FWD photo
Loading ...
Loading ...
Loading ...
CAUTION
Be careful not to burn yourself, as the
engine oil is hot.
WARNING
Prolonged and repeated contact
with used engine oil may cause skin
cancer.
Try to avoid direct skin contact with
used oil. If skin contact is made, wash
thoroughly with soap or hand
cleaner as soon as possible.
Keep used engine oil out of reach of
children.
4. Loosen the oil filter with an oil filter
wrench by turning it counterclockwise.
Remove the oil filter by turning it by
hand.
5. Wipe the engine oil filter mounting sur-
face with a clean rag.
CAUTION
Be sure to remove any old gasket ma-
terial remaining on the sealing surface
of the engine. Failure to do so could
lead to an oil leak and engine damage.
The dipstick must be inserted in
place to prevent oil spillage from the
dipstick hole when filling the engine
with oil.
6. Coat the gasket on the new filter with
clean engine oil.
7. Screw in the oil filter clockwise until a
slight resistance is felt, then tighten addi-
tionally more than 2/3 turn.
Oil filter tightening torque:
11 to 15 ft-lb (14.7 to 20.6 N·m)
8. Clean and re-install the drain plug with a
new washer. Securely tighten the drain
plug with a wrench. Do not use exces-
sive force.
Drain plug tightening torque:
22 to 29 ft-lb (29.4 to 39.2 N·m)
9. Refill the engine with the recommended
oil through the oil filler opening, and in-
stall the oil filler cap securely.
For additional information about drain and
refill capacity, see “Recommended fluids/
lubricants and capacities” (P. 10-2). The
drain and refill capacity depends on the oil
temperature and drain time. Use these
specifications for reference only. Always
use the dipstick to determine the proper
amount of oil in the engine.
10. Start the engine and check for leakage
around the drain plug and the oil filter.
Correct as required. Turn the engine off
and wait more than 15 minutes. Check
the oil level with the dipstick. Add en-
gine oil if necessary.
After the operation
1. Reinstall undercover in reverse order of
removal.
2. Lower the vehicle carefully to the
ground.
3. Reset the oil control system (if so
equipped) and oil and filter maintenance
reminder. For additional information,
see “Vehicle information display 5 inch
(13 cm) Type A” (P. 2-18) or “Vehicle infor-
mation display 7 inch (18 cm) Type B”
(P. 2-33)
Dispose of waste oil and filter properly.
Check your local regulations.
Do-it-yourself 8-11
Loading ...
Loading ...
Loading ...