Loading ...
Loading ...
Loading ...
EN
6
-Stacking kit Mod 35900120: for
minimum washing machine
depth 51 cm
The stacking kit shall be one of that
above, obtainable from our spare
service.
The instructions for installation and
any fixing attachments, are provided
with the staking kit.
Ventilation
• Adequate ventilation must be
provided in the room where the
tumble dryer is located to prevent
gases from appliances burning
other fuels, including open fires,
being drawn into the room during
operation of the tumble dryer.
• Installing the rear of the appliance
close to a wall or vertical surface.
•There should be a gap of at least
12 mm between the machine and
any obstrubtions.The inlet and
outlet should be kept clear of
obstruction.To ensure adequate
ventilation the space between the
bottom of the machine and the floor
must not be obstructed.
• Check regularly that the air
flowing through the dryer is not
restricted.
• Check frequently the fluff filter
after use, and clean, if necessary.
•Prevent items from falling or
collecting behind the dryer as
these may obstruct the air inlet and
outlet
• NEVER install the dryer up
against curtains.
• In cases where the dryer is
installed on top of a washing
machine, a suitable stacking kit
must be used according to the
follow configuration.
-Stacking kit Mod 35100019: for
minimum washing machine
depth 49 cm
Do not install the product in a
low temperature room or in a room
where there is a risk of frost
occurring. At temperature around
freezing point the product may not
be able to operate properly: there
is a risk of damage if the water is
allowed to freeze in the hydraulic
circuit (valves, hoses, pumps). For
a better product performance the
ambient room temperature must
be between +2°C and +35°C.
Please note that operating in cold
condition (between +2 and +15°C)
might simply some water
condensation and water drops on
floor.
INTRODUCTION
SAFETY REMINDERS
Loading ...
Loading ...
Loading ...