Loading ...
Loading ...
Loading ...
12
3. Press and release the MUTE button.
4. Press and release the VOL - button.
The red indicator light will blink twice
and go off.
Direct Code Entry
1. Press and hold the SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the desired device
button (TV, CBL, DVD, DVR) you would
like the code for.
3. Press and release ENTER button.
4. Press and release the #1 button.
Count the number of times the remote
light fl ashes. This is the number
corresponding to the fi rst digit of the
code. Repeat the process by pressing
the #2, #3 and #4 buttons for the
remaining digits.
5. Press and release ENTER button to exit
this mode.
Reset to Factory Settings
1. Press and hold the SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the OK button.
3. Press and release the number #0 button.
The red indicator light will fl ash twice.
Using Your Remote
Loading ...
Loading ...
Loading ...