Loading ...
Loading ...
Loading ...
Appliance door en
31
Removing and fitting the door panels
To facilitate cleaning, you can remove the glass panels
from the appliance door.
Removing the door panels from the appliance
1. Open the appliance door slightly.
2. Press on the right and left side of the cover (fig. !).
3. Remove the cover (fig. ").
4. Undo and remove the screws on the left and right of
the appliance door (fig. #).
5. Before closing the door again, trap a tea towel that
has been folded several times in the door (fig. $).
Pull out the front panel upwards and lay it on a flat
surface with the door handle facing downwards.
6. Push both retainers at the top of the intermediate
panel upwards, but do not remove them (fig. %).
Hold the panel with one hand. Take out the panel.
Clean the panels with glass cleaner and a soft cloth.
:Warning – Risk of serious damage to health!
If the screws are loosened, the safety of the appliance
can no longer be guaranteed. Microwave energy may
escape. Never loosen the screws.
Do not unscrew the four black screws (fig. &).
:Warning
Risk of injury!
Scratched glass in the appliance door may develop
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
Risk of injury!
The hinges on the appliance door move when
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Fitting the door panels on the appliance
When fitting the intermediate panel, make sure that the
arrow is in the top right of the panel and that it aligns
with the arrow on the metal panel.
1. Insert the intermediate panel into the retainer at the
bottom and push it in firmly from the top (fig. !).
2. Push both retainers downwards (fig. ").
3. Insert the front panel downwards into the retainers
(fig. #).
4. Close the front panel until both upper hooks are
opposite the opening (fig. $).
5. Press the front panel down until it clicks audibly into
place (fig. %).
6. Open the appliance door again slightly and remove
the tea towel.
2
1
2
1
Loading ...
Loading ...
Loading ...