Snow Joe SJ617E User Manual

Loading ...

3. Remove the screws and the bushings from the drive wheel

(Fig. 33).

4. Remove the auger axle set (Fig. 34).

5. Remove the old auger from the housing (Fig. 35).

6. Install the replacement auger by following the above steps

in reverse order.

Replacing the Scraper Bar

1. The scraper bar is located at the base of the snow thrower

beneath the rotor housing (Fig. 36).

2. Remove the screws that secure the scraper bar to the

snow thrower (Fig. 37).

3. Install the new scraper bar and fasten it securely to the

snow thrower with the screws.

Replacing the Belt

NOTE: Under normal operating conditions, it should not be

necessary to replace the auger belt. However, should the auger

jam or malfunction, the belt could be damaged. To replace the

belt, follow the instructions.

NOTE: Determine the left and right hand side of the snow

thrower by standing behind the unit in the normal operating

position.

Fig. 33

Screws

Bushing

Fig. 34

Auger axle

set

Fig. 35

Fig. 36

Scraper

bar

Fig. 37

The screws that secure the scraper bar

Loading ...

Snow Joe SJ617E Electric Single Stage Snow Thrower 18-Inch 12 Amp Motor