Loading ...
Loading ...
Loading ...
(174PO) DELUXE POOL MAINTENANCE KIT ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 05/23/2017
S AVE THESE INSTRUCTIONS
174
PO
English
Page 9
POOL VACUUM OPERATING INSTRUCTIONS
1.
The filter pump is an airtight system. To eliminate air trapped in the hose or in the
pump, turn the air release valve (if any) 1-2 turns in a counter-clockwise motion to
open the valve. Refer to the pump owner’s manual for details.
2.
When water starts flowing out of the air release valve hole, screw in the air release
valve back into the filter housing cover. Do not over tighten the valve.
3.
Connect the filter pump to the power outlet and turn ON the pump.
4.
In soft gentle strokes "sweep" the entire bottom surface of the pool liner until it’s
clear of debris.
5.
Make sure the filter pump is turned off, and disconnect the power cord from the
electrical outlet. Remove the pool vacuum from the pool.
6.
Using the Set-Up instructions in reverse, disassemble the vacuum cleaner. Clean
the debris bag if necessary.
7.
Store the pool vacuum in an area where it will not be a safety hazard.
If you experience low suction on the vacuum, check that all of the
air has been removed from the hose. If you still have a low suction
problem, please review the Troubleshooting Guide for your filter pump
under "Filter pump does not pump water or flow is very slow". Also,
check that the debris bag and filter pump cartridge are clean.
IMPORTANT
Loading ...