Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
95
A faucet with a 3/8" GHT connection
must be provided on site. If this type of
faucet is not available, only a qualified
installer may connect the dishwasher to
the domestic water supply.
A back-flow preventer is not required by
the manufacture, but may be required
by local code regulations.
The water-connection pressure needs
to be between 7.25 and 145 psi (50 and
1,000kPa). If the water-connection
pressure is too high, a pressure reduc-
ing valve must be fitted.
Risk of damage from leaking wa-
ter.
The connection point is subject to
domestic water pressure. Water leak-
ing from it can cause damage.
You should therefore open the water
supply slowly and check for leaks.
Correct the position of the washer
and screw thread if appropriate.
Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be oper-
ated when it is connected to a fully
vented plumbing system.
Risk of damage from leaking wa-
ter.
The intake hose is under water pres-
sure.
The intake hose must not be short-
ened or damaged in any way.
Do not sit the dishwasher on the
hose. The hose needs to be free of
kinks and able to move freely after
installation. Do not place hose or
power cord next to a heat source
e.g., hot water pipes. Do not expose
hose or power cord to corrosive sub-
stances (e.g., chloride). Damage of
hose or power cord could cause
electrical shock or water damage.
Loading ...
Loading ...
Loading ...