Loading ...
Loading ...
Loading ...
16 English
Care and service
Floor head cleaning by rinsing
process
ATTENTION
Dirt or detergent residues
The waste water tank and hair filter
must be cleaned regularly so that dirt
does not get stuck in the tank or in the
hair filters. If the device is not cleaned
after it has been used, dirt particles can
clog the hair filters and the slots. Fur-
thermore, the accumulation of dirt and
bacteria can cause an unpleasant odor
in the device.
After finishing work, place the device in
the cleaning station and start the rins-
ing process.
Only clean the floor head in the clean-
ing station with the automatic rinsing
process and not by separately pouring
water into the station. Make sure the
waste water tank is in place.
Do not keep the bottom side of the floor
head underwater.
Note
As long as the display "MAX" (red)
lights up, and the waste water tank has
not been emptied, the rinsing process
cannot be started.
Note
The LED lighting on the floor head is
switched off during the rinsing process.
1. Press the ON / OFF switch.
The device switches off.
2. Empty and reinsert the waste water
tank (see chapter Emptying the
waste water tank).
3. Place the device with the empty waste
water tank in the cleaning station.
4. Fill the fresh water
tank with 6.76 oz
(200 ml) fresh water without deter-
gent or care agents (see chapter
Filling the fresh water tank).
Note
It is not necessary to add detergents
during the rinsing process.
5. Hold down the ON / OFF switch and
the button for setting the cleaning
level simultaneously for 3 seconds.
A signal tone sounds.
b
a
6.76 oz /
200 ml
Loading ...
Loading ...
Loading ...