Loading ...
Loading ...
Loading ...
ENGLISH
7
2. Lift the bottle safely (see assembly above) and place
bottle until it's secure and bottle is seated.
3. Plug the cord into a properly grounded wall outlet. WARNING: Always
make sure that the cord is away from a water source.
Dispensing Cold Water
After setup, it will take up to a couple of hours to get the water to its maximum cold
temperature. When it reaches max temperature, the green light will turn o.
1. Place bottle, glass, or pitcher below the cold water tap.
2. Push the cold water dispenser forward to start dispensing water.
3. Release/pull back from the dispenser once the desired ll level is achieved.
Dispensing Hot Water
After setup, it will not take long to reach maximum hottest temperature. When it reaches hottest
temperature, the red light will turn o. NOTE: For safety, there is a lock on the dispensing button.
1. Place bottle, glass, pitcher, pot below the hot water tap.
2. Release child-safety lock by pushing the red button and then push the hot water
dispenser forward with the cup at the same time to start dispensing water.
3. Release/pull back from the dispenser and release the
button once desired ll level is achieved.
NOTE: Be careful when dispensing hot water as temperature can reach 203 °F.
Replacing An Empty Bottle
Replace the bottle as soon as you notice that it is empty.
1. Lift the bottle straight up to disengage it from the bottle probe.
2. Remove the tamper seal from the bottle cap of the NEW
bottle. DO NOT remove the plastic cap.
3. Lift the bottle and insert it (assembly directions above). Apply slight pressure
until the plug inside the cap pushes in and the bottle is secure.
HELPFUL TIPS
DISPENSER IS NOT WORKING
• Make sure that the power cord is properly connected to a working outlet.
WATER IS LEAKING
• Replace water bottle. Most common cause is a cracked bottle.
NO WATER IS COMING OUT
• Make sure bottle is not empty. If so, replace it.
• Make sure that you fully press the water control buttons.
WATER DISPENSER IS NOT COLD
• Make sure cold switch is ON. Switch is located in the back of the water cooler.
• It can take up to six hours after setup to dispense coldest water.
• Make sure back of the dispenser is at least 4 inches from a wall
and that air is free to ow on all four sides of dispenser.
Loading ...
Loading ...
Loading ...