Loading ...
Loading ...
Loading ...
9
12. CONNECT WIRING (ALL BLOWERS)
WARNING
!
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power to be switched on accidentally.
INTERIOR BLOWER: Connect cable into wiring box using wire connectors.
Connect wires as follow: BLACK to BLACK, WHITE to WHITE and
GREEN or bare wire under ground screw. Reinstall wiring cover.
DO NOT FORGET TO CONNECT THE GROUND.
IN-LINE OR EXTERIOR BLOWER: Remove rough-in plate wiring cover and connect wiring (see instructions included with in-line or
exterior blower).
HE0012
GROUND SCREW
11. INSTALL THE HOOD (ALL BLOWERS)
Run power cable to installation location. Place the hood to its location. Mark the position of the screws (smaller part of the key holes)
with a pen. Remove the hood and install the (8) 1/2” double thread screws leaving a 1/8” gap (4 screws for 30” hood). Remove wiring
cover, place the wire clamp, insert the cable in the hood and tighten the wire clamp to secure the cable. Place the hood under the
cabinet and slide it in position. Make sure the adapter/damper assembly enters the ducting. Secure the hood by tightening the screws
completely.
HD0043
Run power cable to installation location. Place the hood to its location. Mark the position of the screws (smaller part of the key holes)
with a pen. Remove the hood and install the (8) 1/2” double thread screws leaving a 1/8” gap (4 screws for 30” hood). Remove wiring
cover on top of the hood and connect wiring (see instructions included with exterior blower). Place the hood under the cabinet and
slide it in position. Secure the hood by tightening the screws completely.
INTERIOR BLOWER
IN-LINE OR EXTERIOR BLOWER
Loading ...
Loading ...
Loading ...