1. Home
  2. Honeywell
  3. Honeywell 8732401 User Manual
  4. Page 6

User Manual - Page 6

For 8732401.

Loading ...
Loading ...
Loading ...
Page 4
NOTE: Tailpiece must be
positioned vertically
INSTALLINGEXTERIORASSEMBLY
7. SECURING THE EXTERIOR ASSEMBLY TO THE DOOR
a.Fromthesidemarked“Thissideagainstdoor”,
route the Control Wire through the rectangular
slotintheMountingPlate(Figure7a).
b.PlaceMountingPlateagainstdoorwithtailpiecepassing
throughthecenterholeinthethreeholeset(Figure7b).
c.SecuretheMountingPlatetotheExteriorAssemblyusing
two7/8”(22mm)Screws(Figure7c).
d.HandtightenwithaPhillipsScrewdriverleavingloosely
connected(Figure7d).
e.CheckthattheRubberGasketisproperlyalignedandcorrectasnecessary(Figure7e).
f.Checkverticalalignmentofthelock(Figure7f).
g.TightensecurelywithahandheldPhillipsScrewdriver.DO NOT OVER TIGHTEN
8. OPTIONAL INSTALLATION
a.Usinga1/16”(2mm)drillbit,drillapilotholeinyourdoor
usingtheMountingPlateupperholeasaguide(Figure8a).
b. Insert one 3/4”(19mm)screwandtighten.
Mounting Plate
3/4”(19mm)screw
(OptionalInstallation)
7/8”(22mm)screws
Control Wire
Figure8a
Figure7a-7f
NOTE: Rotate knob to ensure the latch is opening and closing easily.
6. INSTALLING THE EXTERIOR ASSEMBLY
Note: WorkwiththeDoorOpenforeasyaccess.Toaccessthemountingplate,unpack
theInteriorAssemblyandremovethebatterycoverbyslidingthecoverupward.Locate
thescrewsholdingtheMountingPlatetotheInteriorAssembly.Removethescrewsto
releasetheMountingPlatefromtheInteriorAssembly.
a.UnpacktheExteriorAssembly.Usecaretonotscratchthegreencircuitboard
during handling and installation.
b.CheckthattheRubberGasketisproperlyseatedontheExteriorAssembly
(Figure6a-b).
c.InserttheExteriorAssemblyontothedoorwiththetailpiecegoingthroughthe
Latch spindle in the VERTICAL POSITION. Route the Control Wire through
thedoorovertheLatch(Figure6c).
Rubber
Gasket
Control
Wire
Tailpiece
(Vertical)
Latch
Hole
Figure6a-b Figure6c
Loading ...
Loading ...
Loading ...