Loading ...
Loading ...
Loading ...
6
CLEARING ALL LEARNED IR CODES
Press and hold the Source
button on the sound bar for
about 10 seconds. When the all LEDs on the front of the
soundbar blink in purple five times, release the button.
BASIC TROUBLESHOOTING
The HDMI Control function does not work
・ You cannot operate devices that are not compatible with
the HDMI Control function. In addition, depending on the
connected device or the settings, the HDMI Control function
may not work. In this case, operate the external device
directly.
・ Check that the HDMI Control function setting is enabled on
all devices connected to this unit.
No sound is produced from subwoofer
・ The Signa S3 sound bar and wireless subwoofer are preset
at the factory to work together. Should your wireless
subwoofer stop receiving an audio signal, follow these
instructions to re-establish the connection:
1. Turn on your sound bar.
2. Press and hold the CONNECT button on the back of the
subwoofer for 3 seconds.
3. Simultaneously press and hold Bluetooth
and Volume
Up + buttons on the sound bar for 5 seconds.
The sound bar will search for a connection while the first and
second LEDs on the sound bar will flash intermittently. The
lights will stop flashing when the sound bar and subwoofer
connect. If the sound bar and subwoofer fail to connect, the
first and second LEDs will flash together 5 times. Repeat
steps above to establish a connection.
Cannot pair with a Bluetooth device
・ It may be that Bluetooth is not enabled on the Bluetooth
device. See the Owner’s Manual of the Bluetooth device to
enable the Bluetooth function.
・ This device may be paired with another Bluetooth device.
Select this unit from the list of devices displayed on the
screen of the Bluetooth device.
・ Bring the Bluetooth device near to this unit.
・ Turn the power of the Bluetooth device off and on again,
and then try again.
・ Only 1 Bluetooth device can be connected at a time.
The sound from a Bluetooth device is cut o
・ Bring the Bluetooth device near to this unit.
・ Remove obstructions between the Bluetooth device and this
unit.
・ To prevent electromagnetic interference, locate this unit
away from microwave ovens, wireless LAN devices and
other Bluetooth devices.
・ Pair with the Bluetooth device again.
Resetting factory settings
Perform this procedure if the display is abnormal or if
operations cannot be performed. Various settings are reset to
the factory default values. Make settings again.
1. Press thePower On/O
button to turn on power to the
unit.
2. Press and hold the back panel’s RESET button for at least 5
seconds.
・ All the Front LEDs blink simultaneously 3 times in red.
・ Signa S3 automatically restarts in a factory default values.
Specifications
Sound bar Subwoofer
Power supply: AC 100 - 240 V,
50/60 Hz
AC 100 - 240 V,
50/60 Hz
Operating temperature: 5 °C - 35 °C 5 °C - 35 °C
Power consumption: 40 W 40 W
Power consumption in standby
mode: 1.80W 0.35W
Power consumption in deep
standby mode: 0.35W 0.35W
Polk SignaS3_QSG_200302.indd 6Polk SignaS3_QSG_200302.indd 6 2020/03/03 17:00:292020/03/03 17:00:29
Loading ...
Loading ...
Loading ...