Loading ...
Loading ...
Loading ...
English 13
Note
Your water board or municipal utilities authority can pro-
vide information on hardness of tap water.
ATTENTION
Damaged surfaces
The descaler may corrode sensitive surfaces.
Fill and empty the appliance carefully.
1. Switch off the appliance, see Chapter Switch off the
appliance.
2. Allow the appliance to cool down.
3. Unscrew the safety lock.
4. Drain the water completely out of the steam boiler.
Illustration R
ATTENTION
Appliance damage due to descaler
An unsuitable descaler or incorrect dosing of the descal-
er may damage the appliance.
Only use KÄRCHER descaler.
Use 1 dosing unit of the descaler for 0.5 l water.
5. Apply descaler solution to the descaler according to
the details.
6. Fill the descaler solution into the steam boiler. Do
not seal the steam boiler.
7. Allow the descaler solution to take effect for
approx. 8 hours.
8. Drain descaler solution completely out of the steam
boiler.
9. Repeat the descaling process if necessary.
10. Rinse the steam boiler 2-3 times with cold water in
order to drain all the descaler solution residue.
11. Drain the water completely out of the steam boiler.
Illustration R
Care of accessories
(Accessories - depending on scope of delivery)
Note
The floor cleaning cloth and the cover for the manual
nozzle have been washed beforehand and can be used
immediately for working with the appliance. The micro
fibre cloths are not suitable for dryer.
Note
When washing the cloths, observe the instructions on
the washing tag. Do not use any liquid softeners as this
will affect the ability of the cloths to pick up dirt.
1. Wash the floor cleaning cloths and covers at a max.
temperature of 60 °C in the washing machine.
Troubleshooting guide
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
몇 WARNING
Risk of electric shock and burns
Trying to eliminate faults while the appliance is connect-
ed to the mains or has not yet cooled down is always
dangerous.
Remove the mains plug.
Allow the appliance to cool down.
Reduced steam quantity
The steam nozzle is blocked.
1. Disconnect the accessory from the steam nozzle.
2. Clean the nozzle insert.
3. Start up the appliance briefly.
4. Attach the accessory to the steam nozzle.
The steam boiler is scaled.
Descale the steam boiler
No steam
No water in the steam boiler
Refill water, see Chapter Refilling water.
The switch cannot be pressed
The switch is locked with the child lock.
Push the child lock up.
The switch is unlocked.
High water egress
The appliance is “spitting out” water
Do not incline the appliance more than 30° (maxi-
mum angle) to the side during cleaning.
Do not exceed the maximum filling quantity of
200 ml.
Technical data
Subject to technical modifications.
Hardness range °dH mmol/l KF
I soft 0-7 0-1.3 35
II Medium 7-14 1.3-2.5 30
III Hard 14-21 2.5-3.8 20
IV Very hard >21 >3.8 15
Electrical connection
Voltage V 220-240
Phase ~ 1
Frequency Hz 50-60
Protection class IPX4
Protection category I
Performance data
Heating capacity W 1200
Maximum operating pressure MPa 0.3
Heating-up time Minutes 3
Continuous steaming g/min 35
Maximum steam blast g/min 80
Filling quantity
Steam boiler ml 250
Maximum filling quantity ml 200
Dimensions and weights
Weight (without accessories) kg 1.5
Length mm 321
Width mm 127
Height mm 186
Loading ...
Loading ...
Loading ...