Loading ...
Loading ...
a
Masking Tape
Cutout Are
Position the template on the countertop in the location you wish to install the sink. Check
to make sure that the sink bowl(s) will not interfere with the cabinets below. Attach the
template to the countertop with masking tape and trace the cutout line with a pencil.
Remove template from countertop before proceeding.
Or (Without Template)
Invert sink and position onto the counter-top. Check to make sure that the sink bowl(s)
will not interfere with the cabinets below. Trace a pencil line around the outside edge of
the sink and remove the sink from the countertop. Measure in ⁄” (10mm) from the initial
sink outline and draw a second line inside the rst, this is the cut out line.
Drill a starter hole inside of cutout line using a drill bit sized to allow the saber saw blade
to be inserted for cutting. NOTE: The starter hole must be fully inside of the cut out line.
Step 1
Step 2
Using a saber saw, cut inside of cutout Line. Place sink in cut out hole and check for
proper t.
Step 3
Step 4
Identify xture hole locations for faucet, spray or soap dispensers . Drill a starter hole
from reverse side of the countertop. Working from the top side of the countertop drill the
appropriate number of holes using a 1¼” (32 mm) using a hole saw position on the starter
hole, through the countertop. To cool the hole saw and sink surface, a light application
of water, periodically, is necessary. Attach faucet, drain, and accessories according to
manufacturer’s instructions.
Loading ...