Loading ...
Loading ...
Loading ...
English
8
Fig. C
9
1
Trigger Switch and Forward/Reverse
Button (Fig. D)
• The drill is turned ON and OFF by pulling and releasing
the trigger switch
3
shown in Figure D. The farther the
trigger is depressed, the higher the speed of the drill.
• A forward/reverse control button
4
determines the
rotational direction of the tool and also serves as a lock
off button.
• To select forward rotation, release the trigger switch and
depress the forward/reverse control button on the right
side of the tool.
• To select reverse, depress the forward/reverse control
button on the left side of the tool.
• The center position of the control button locks the tool
in the off position. When changing the position of the
control button, be sure the trigger is released.
Fig. D
3
4
Adjusting Torque Control (Fig. A)
This tool is fitted with a torque adjustment collar
5
to select
the operating mode and to set the torque for tightening
screws. Large screws and hard workpiece materials
require a higher torque setting than small screws and soft
workpiecematerials.
• For drilling in wood, metal and plastics, set the collar to
the drilling position symbol
• For screwdriving, set the collar to the desired setting. If
you do not yet know the appropriate setting, proceed
as follows:
- Set the collar to the lowest torque setting.
- Tighten the first screw.
- If the clutch ratchets before the desired result
is achieved, increase the collar setting and
continue tightening the screw. Repeat until you
reach the correct setting. Use this setting for the
remainingscrews.
Speed Selector (Fig. E)
The speed selector feature of your drill allows you to shift
gears for greater versatility.
• To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide speed selector
6
away from the chuck.
• To select the high speed, low torque setting (position2),
turn tool off and permit to stop. Slide speed selector
back toward the chuck.
nOTE: Do not change gears when tool is running. If you are
having trouble changing gears, make sure that the speed
selector is either completely pushed forward or completely
pushed back.
Fig. E
6
Keyless Chuck (Fig. F)
WARNING: Make certain the battery pack is removed
to prevent tool actuation before installing or
removingaccessories.
To insert a drill bit or other accessory:
1. Grasp the keyless chuck
7
and rotate it in the
counterclockwise direction, as viewed from the
chuckend.
2. Insert the bit or other accessory fully into the chuck, and
tighten securely by rotating the chuck in the clockwise
direction as viewed from the chuck end.
WARNING: Do not attempt to tighten or loosen drill
bits (or any other accessory) by gripping the front
part of the chuck and turning the tool on. Damage
to the chuck and personal injury may occur when
changingaccessories.
Loading ...
Loading ...
Loading ...