Loading ...
Loading ...
Loading ...
33
OPERATION
ENGLISH
NOTE
• The icemaker begins producing ice
approximately 48 hours after the appliance is
initially installed. The first batches of ice may not
be round and clear.
• Following installation or water filter
replacement, the first few batches of ice may be
semicircular or contain air bubbles.
• If the water pressure is less than 20 psi (138 kPa)
or a reverse osmosis system is used, the shape
of the ice may vary.
• The ice may look cloudy depending on the water
quality in the installation location and the
operating conditions.
• Throw away any shards of ice you may find in the
ice bin, as they may stick to the ice stored in the
ice bin.
• After a short term power outage, it will take
longer to make the first batch of ice, and the ice
may not be round. If the power will be out for a
longer period, throw away the ice stored in the
ice bin.
• The
Craft Ice
icemaker produces 1 batch of
round ice (3 pieces) at a time.
• In
3 ICE
mode, the
Craft Ice
icemaker produces
1 batch of round ice (3 pieces) about every 24
hours. In
6 ICE
mode, the
Craft Ice
icemaker
produces 2 batches of round ice (6 pieces total)
in the same period.
• For more ice, select the
6 ICE
mode. For clearer
ice, select the
3 ICE
mode.
• The time needed to make ice may vary according
to operating conditions.
• The ice bin stores 20 - 30 pieces of round ice.
Removing/Refitting the Ice
Storage Bin
The ice dispensing chute may become blocked with
frost if only crushed ice is used. Remove the frost
that accumulates by removing the ice bin and
clearing the passage with a rubber spatula.
Dispensing cubed ice periodically can also help
prevent frost buildup.
1
Turn off the automatic icemaker. Press and
hold the
Ice On/Off
button on the control
panel for 3 seconds.
2
Hold and remove the cover of the automatic
icemaker by lifting it upward.
3
Hold the ice bin with both hands and pull it out
while lifting it upward.
4
Refit the in-door ice bin in the reverse
sequence of their removal.
CAUTION
• Do not touch the automatic icemaker’s
mechanical parts with your hand or a tool.
Otherwise, appliance damage or injury may
occur.
• Do not disassemble, repair or alter the
automatic icemaker. These tasks should only be
done by a service technician.
• Caution should be taken, as the automatic
icemaker operates continuously after the freezer
door is opened when the automatic icemaker
switch is set to the on position.
• Keep children away from the dispenser.
• When refitting the ice bin, ensure that it is placed
correctly. If it is tilted or unlevel, it may not
continue to make ice due to sensor disruption.
global_main.book.book Page 33 Monday, May 31, 2021 11:32 AM
Loading ...
Loading ...
Loading ...