Loading ...
Loading ...
Loading ...
INSTALLATION MANUAL
INSTALLATION
10
4 ] Remove both tape strips holding the 7” round adapter (not included with BPDC Series), and
put the adapter aside.
5 ] Remove the screw holding the 3¼” x 10” adapter/damper and put the adapter/damper aside.
Save this screw, it will be used later to hold the cover plate.
6 ] Remove the parts bag taped in the lower left corner of the hood.
7 ] Using a 11/32” nut driver or socket, remove the lock nut retaining the flange of the right cover
plate (shaded part on illustration below) to the inner back of hood (see inset). Remove the
right cover plate retaining screws (7 screws), then set the blower cover along with its screws
and nut aside.
NOTE: For 30 in.-wide hoods, slightly lift up the cover plate before sliding it towards the left to
remove it.
1
2
3
45
6
7
BACK OF HOOD
LOCK NUT
SCREW REMOVED
IN STEP 5
REMOVE
AND SAVE
THIS
SCREW
TAPE
TAPE
TAPE
PARTS BAG
Loading ...
Loading ...
Loading ...