Loading ...
Loading ...
Loading ...
25
7.3 Post installation control
Check that the front levelling feet have been pro-
perly installed.
Check that the connection to the water system
does not have any leaks and that the shut-o valve
is easily accessible.
Check that the electrical connection is correctly
installed and that the socket and / or breaker are
easily accessible.
Check the perfect alignment of the appliance
with adjacent structures.
Check that all adhesive tape and external or in-
ternal temporary protective devices have been re-
moved.
Check the perfect closing of the doors and the
smooth sliding of the drawers and shelves.
7.4 Start up
> To start the appliance, connect the plug to the
electrical mains: at this point, when opening the
door, the control panel will usually visualize the
message “Stand by”, and all the panel keys will
be off
>To turn on all the appliance compartments,
press the Unit button for three seconds. The
display will show the message “Initial test” for
approximately 2 minutes. After this phase the
compressors will start up and remain on until the
compartment set temperatures are achieved.. Do
bear in mind that this condition could last several
hours during which time the display will continue
to flash the ‘Start Up Phase’ message.
> If the appliance is provided with an Ice Maker,
prior to switching it on make sure that the water
filter cartridge is installed (unless water supply
source is already filtered by other means such as
reverse osmosis).
> Purge air from the water lines by performing
the ‘Manual Clean’ function from the Menu-
>Functions->Water Filter options. You may need
to complete this sequence several times until you
stop hearing air sputtering from the ice maker fill
tube (Refer to your Use & Care Manual).
> Once you are satisfied that the system is pur-
ged of air switch the Ice Maker on by touching the
Ice Maker Water Filter
Water System Purge
button which will illuminate.
> For further information about the appliance
operation, refer to the User Manual.
If at the first start - up the message Stand
by does not appear, but other messages
appear, such as Fridge too warm, Freezer
too warm, or sound signals are activated, it
means that the appliance has already pre-
viously started the cooling process. If this is
the case, deactivate any possible acoustic
signals by pressing the Alarm button, close
the door and wait until the set temperature
is reached.
It is necessary to let the unit reach the correct
temperature before foods are stored inside.
Bertazzoni is constantly researching new way to
improve the features and the design of their pro-
ducts, therefore models are often upgraded and
revised.
EN
Serigraa
VETRO B02961702 USER 599/24” TFT - BERTAZZONI
bianco EB 61 - 62 li
Fondo o ultimo passaggio:
passaggio di nero coprente 602 -95 li
forato solo per le parti retro illuminate come da disegno “C”
Nomenclature: Grigio Whirlpool
Limite per graca parti retro-illuminate
C
Testo e graca
cambiamento dimensioni foro
56x43mm 29-05-2019
pareti verticali 29-05-2019
dimensioni icone 90%
00
°C+
Impostazioni
Funzioni
00
°C+
00
°C-
BISELLATURA SUI 4 LATI
Loading ...
Loading ...
Loading ...