Loading ...
Loading ...
Loading ...
User Manual of LV-N9916C6E Series NVR
130
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
LV-N99xx
Figure 9. 1 Network Settings Interface
3. In the General Settings interface, you can configure the following settings: Working Mode, NIC Type, IPv4
Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.
Note: For the LV-N99xx series NVR, you need to configure the internal NIC address, so that IP addresses are
assigned to the cameras connected to the PoE interfaces.
Note: The valid value range of MTU is 500 ~ 9676.
4. After having configured the general settings, click to save the settings.
Multi-address Mode: The parameters of the two NIC cards can be configured independently. You can select
LAN1 or LAN2 in the NIC type field for parameter settings.
You can select one NIC card as default route. And then the system is connecting with the extranet the data will be
forwarded through the default route.
Net-fault Tolerance Mode: The two NIC cards use the same IP address, and you can select the Main NIC to LAN1
or LAN2. By this way, in case of one NIC card failure, the device will automatically enable the other standby NIC
card so as to ensure the normal running of the whole system.
Load Balance Mode: By using the same IP address and two NIC cards share the load of the total bandwidth, which
enables the system to provide two Gigabit network capacity.
Loading ...
Loading ...
Loading ...