Loading ...
Loading ...
Loading ...
7
Lubrication
The bearings in the sweeper have been pre-lubricated at
the factory. However it’s recommended that a few drops of
light oil should be added to the brush shaft bearings twice a
year. Also, the gear should be cleaned every two years. After
cleaning apply an even coat of light grease.
1. Use a screw driver to pop o the hub cap (Fig. 12).
2. To remove the wheel, take out the circlip and the at
washer; you will see the gear and the shaft (Fig. 13).
3. Remove the circlip on the gear, the gear can be taken o
easily (Fig. 14).
4. Clean the gear and lubricate the shaft as needed, then
reassemble the wheel in a reverse sequence.
Fig. 12
Hub cap
Fig. 13
Circlip
Flat washer
Wheel
Gear
Shaft
Fig. 14
Circlip
Gear
Loading ...
Loading ...
Loading ...