Loading ...
Loading ...
Loading ...
Maintenance
How to Clean Your Ceiling Fan Blades
1. ylnoehtsinafgniliecwenruoyfogninaelccidoireP
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth
.hsinif ehtgnihctarcsdiovaot
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
Periodic light dusting of the blades is recommended.
A feather duster will work best.
Avoid using water, cleansers, or harsh rags, which can
warp and ruin the blades.
CAUTION
Do not use solvents when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of electrical shock.
RECOMENDED: Periodically check that the blade holders to motor hub screws are secure and tight.
11
How to Operate Your Remote Control (continued)
Figure 4
NOTE: Transmitters can pair to multiple receivers,
when performing the pairing process take care not
to pair the transmitter to unintended receivers. It is
suggested that fans more than seven feet apart be
on separate power switches.
4. Pairing Process for Receiver & Transmitter:
(Figure 4)
– The receiver and accompanying transmitter are
matched at the factory. If replacing transmitter or
receiver, you must follow the pairing process below
before using the unit. The fanSync receiver can be
paired to up to five (5) transmitters.
NOTE: Smart device pairing is unlimited.
– After installing the receiver unit, set desired
transmitter code by pushing dip switches (under
battery cover) up or down to the desired positions.
Once code is set, restore power to your fan and press
and hold the fan off button ( ) for approximately 1 to 3
seconds. Fan will turn off, then turn on to medium
speed to indicate that the pairing process is complete.
Please note that you must press the fan off button ( )
within 30 seconds after restoring power. Re-pairing
your device is not necessary after replacing the battery.
Each fanSync receiver can pair to five different
transmitters (with different dip switch codes).
CR2430 3V
ON DIP
Dip Switch
Dimmer Switch
DIMMER
ON/OFF
Figure 1
How to Install Your Remote Control
1. Installing Wall Plate: (Figure 1)
Attach wall plate using the two provided screws.
Loading ...
Loading ...
Loading ...