Loading ...
Loading ...
Loading ...
6
Install weight (part #25) at the lowest point on the
pull out hose (part #1) as shown on diagram. Tighten
screws on weight with Phillips screwdriver.
Connect spray hose to quick-connecon hose unl you hear "click". The p of the quick-connecon
should spring back to original posion. Test by pulling both ends to make sure they do not separate.
Faucet Installation Procedures
LPFK
Important
Run water out of Hot and Cold angle valves to ush debris
before connecng the water supply lines(#11 ).Place a
bucket under the valve. When valve is turned on water will
shoot up . Cup over the valve opening so water will fall into
the bucket.
Make sure O-ring is in the end of the preinstalled Hot and
Cold water lines.
Connect Hot & Cold water lines to angle valves. Tighten
securely, but do not overghten.
Loading ...
Loading ...
Loading ...