Loading ...
Loading ...
Loading ...
21
Mode pushbutton
Function: it turns hood motor on and off.
The function “desired speed” enables to start the motor at the speed that
was selected before the hood was last turned off.
Optional: version with remote control (some versions only).
WARNING:
Install the hood away from sources of electromagnetic waves, as these
could affect the correct operation of the electronic system.
Maximum operating distance: 5 metres. The maximum operating distance
could be less than 5 metres in case of electromagnetic interference by
other equipment.
Light pushbutton on remote control: light on/off.
– and + pushbutton: increase/decrease speed (to start the motor press
either the + or the – pushbutton).
Timer pushbutton: see instructions below.
Timer and ‘filter clogged’ alarm pushbutton
- This function allows the automatic turning off of the hood after running
for 15 minutes at the speed previously set (the pushbutton shows a flicker-
ing light).
- After about 30 hours of running the pushbutton indicates the need for
washing the metal filters (the pushbutton shows a solid red light). To dis-
able the alarm press the pushbutton for a few seconds until the red light
turns off. Then turn the hood off and on again to check that the alarm has
disappeared.
2. DIMMER
At the bottom of the hood there is a dimmer for the adjustment of the
ambient lights.
a) Knob dimmer: turn the knob clockwise to increase light intensity and an-
ticlockwise to decrease it. To turn the light off turn the knob anticlockwise
till the OFF click. To turn it on, turn the knob clockwise till the ON click.
b) Soft- touch dimmer: keep the button pressed to increase or decrease light
intensity.
c) Dimmer with functions integrated in the control panel: with the motor
turned off and by holding down the light button on the control panel for a
while (2 seconds) you automatically decide on the mode of the light inten-
sity (incandescent light globe). By pressing on + and on – you can adjust
the intensity of the light. With the motor running, the prolonged pressing
of the button down, will turn the atmosphere light on or off.
To replace the incandescent light bulb:
1) make sure that the hood is disconnected from the power supply;
2) remove the decorative glass (refer to section O);
3) fit a new light bulb of the same model (max. 25W);
4) replace the decorative glass (refer to fig. O5).
Loading ...
Loading ...
Loading ...