Loading ...
Loading ...
Loading ...
11
Installing the Door Handle
To install the door handle:
1. Open the door and carefully pull the door gasket around the area where the handle is to
be installed.
2. Carefully remove the two pre-installed decorative plugs from the front of the door.
3. Insert each Phillips head screw through the gasket side of the door until the screw
passes through the door.
4. Align the handle with the screws and tighten using a Phillips head screwdriver until the
handle is ush against the door frame.
5. Carefully press the door gasket into its original position.
Note: Some wine refrigerators do not have decorative plugs installed.
Warning: Do not over-tighten the screws as this may cause damage to the handle or the
stainless steel door.
!
Installing the Shelves
To prevent damaging the door gasket, make sure to open the door fully before pulling the
shelves o their tracks.
1. Open the door completely.
2. Note the location of the protective stoppers on the right and left side of the back of each
shelf.
3. Lift either side of the shelf to create a 45° angle.
4. Insert the shelf at the desired shelf slot and push back slowly until it stops in place.
5. Gently lower the shelf down into place.
Removing the Shelves
1. Open the door completely.
2. Make sure the shelf is pushed in completely towards the back of the refrigerator.
3. If necessary, make sure you remove all the contents sitting on the shelf.
4. Lift either side of the shelf to create a 45° angle and raise the shelf slightly to avoid the
shelf mounts on the inside of the cabinet.
5. Pull the shelf straight out until it is completely removed. Set aside gently.
Loading ...
Loading ...
Loading ...