Loading ...
Loading ...
Loading ...
7
To set up the headphones with the transmitter:
1. After setting up the transmitter (see above), set the Power switch on the transmitter to On.
2. After installing the included batteries in the headphones and charging them (see Powering
the Headphones), press and hold the power button on the headphones for about 2
seconds. The light next to the button will turn red.
3. Wait a few seconds for the headphones and transmitter to connect wirelessly to the
transmitter. When properly connected, the light on the headphones will be green.
To adjust the volume on the headphones, use the + and – buttons on the headphones (when
they are powered on).
Troubleshooting
If you do not hear any sound in the headphones:
• Make sure the power adapter is properly connected to both the power outlet and the
power input on the transmitter’s rear panel. Also make sure the Power switch on the
transmitter’s rear panel is set to On. The Power light on the front panel should be blue.
• Make sure the headphones are powered on and fully charged. The status light next
to the power button should be green. See Setup > Powering the Headphones for
more information.
• Make sure your sound source (TV, receiver DVD player, etc.) is powered on with its
volume at an audible level.
• Make sure the headphone volume is at an audible level. Use the – and + buttons to
adjust it.
If the sound in the headphones is distorted or “clipping”:
• Make sure the headphone volume is not too high. Use the – and + buttons to adjust it.
• Make sure the headphones are close enough to the transmitter. Also make sure
there is a clear line of sight between the headphones and the transmitter.
• Make sure the volume of your sound source (TV, receiver, DVD player, etc.) is at an
audible level.
• If you connected the transmitter to a TV, receiver, DVD player, or hi-fi system, make
sure the Att. switch on the transmitter’s rear panel is set to -8 dB.
If the Optical/Coaxial light is flashing (when the source switch is set to Optical):
• Make sure the included optical cable is securely connected to both the Optical input
on the transmitter’s rear panel and the optical output of your sound source (TV,
receiver, etc.).
Loading ...
Loading ...
Loading ...