Loading ...
Loading ...
Loading ...
11
CONTROL PANEL
ON/OFF Power
To turn the appliance ON or OFF, touch the
symbol and hold for 5 seconds.
NOTE: Touching the POWER key once can switch off the audible alarm when the alarm is on.
LIGHT
Turns the inner light ON and OFF.
UP
Used to increase (warm) the set temperature by 1°C/1ºF.
DOWN
Used to decrease (cool) the set temperature by 1°C/1ºF.
ºF/ºCSelector
Select the temperature display setting in Fahrenheit or Celsius degrees. To change the temperature
from Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold the LIGHT key for 5 seconds.
Setting the Temperature Control
You can set the temperature by touching the UP and DOWN symbols. When you touch the two
buttons for the first time, the LED readout will show the original temperature set previously. (The
temperature preset at the factory is 38°F or 3°C.)
The temperature you are setting will increase by one degree each time you touch the UP
symbol, and will decrease by one degree each time you touch the DOWN symbol.
The range of the temperature control is from 36°F to 43°F.
To view the set temperature at any time, touch the UP or DOWN symbol. The set temperature
will flash in the display window for 5 seconds. After 5 seconds, the temperature inside the unit
will reappear in the display window.
INTERIOR LIGHT
The interior light makes it easy to view the contents and enhances the display of your collection. Touching
the LIGHT symbol toggles between 2 modes of operation for the internal lights: functional (default) mode
and showcase mode. If you are in functional (default) mode, the lights will turn on only when the door is
open. If you are in showcase mode, the lights will be on whether or not the door is open.
NOTE:
If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
When you use the unit for the first time or restart the unit after it has been shut off for a long
time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.
Loading ...
Loading ...
Loading ...