Loading ...
Loading ...
Loading ...
14
5. Attach garden hose to water supply (Fig. 19).
mWARNING! Water that has owed through back ow
preventers is considered to be non-potable.
mWARNING! The water supply must not exceed 0.7Mpa.
6. If only using the base unit, turn the water supply tap on
completely.
7. Push the safety lock on the spray gun handle, then press
the trigger for a few seconds until the water ow is steady.
Operating the pressure washer in this manner will allow
air to escape and discharge residual pressure in the hose
(Fig. 20).
8. Keeping the trigger pressed, turn on the unit by pressing
the On/O button on the control panel. Using the "Pressure
Select" feature, you can also choose from three dierent
pressure settings by pressing the + or - button on the right
side of the control panel (Fig. 21).
NOTE: This machine is equipped with 3 selectable power/
pressure levels. See table below for detailed specs.
9. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts o when the trigger is released.
Fig. 18
Base unit
Garden hose adapter
Garden hose
Water inlet
Fig. 19
Connect to water supply
Garden hose
Fig. 20
Trigger
Safety lock
+
P
O
W
E
R
PRESSURE SELECT
Fig. 21
Control panel
Power
Light
indication
Ratedow
Rated
pressure
– On
– O
– O
Low 0.66 GPM 507 PSI
– On
– On
– O
Medium 0.75 GPM 650 PSI
– On
– On
– On
High 0.79 GPM 800 PSI
Loading ...
Loading ...
Loading ...