Loading ...
Loading ...
Loading ...
13
mWARNING! Before performing any maintenance, always
disconnect the power supply to the unit and wait until the tine
cylinder comes to a complete stop. Wear protective gloves
when handling the tines.
1. Remove the thatch collection bag.
2. Place the machine upside down on a at stable surface to
access the underbody.
3. Loosen the two bolts with a suitable wrench, remove them
together with the spring washers and the attached cutting
device (Fig. 14).
4. To remove the cutting device, rst lift the bearing and then
pull it out from the drive shaft.
5. Align and insert the respective cutting device: Slide the
hex nut into the socket of the drive shaft and x the
bearing to the support with the bolts and spring washers
(Fig. 15).
NOTE: If you have any questions, please call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-766-9563
(1-866-SNOWJOE) for assistance.
After Use
1. Switch the machine o, disconnect it from the power
supply and let it cool down.
2. Check, clean and store the machine as described below.
Thatch Collection Bag
1. Inspect the thatch collection bag before each use. Do not
use it if you nd any damage.
2. Clean the thatch collection bag after operation. Let the
thatch collection bag dry thoroughly before storing to
avoid mildew.
Transportation
1. Switch the product o and disconnect it from power
supply before transporting it anywhere.
2. Attach transportation guards, if applicable.
3. Adjust the cutting depth to the transportation stage (refer
to “CUTTING DEPTH ADJUSTMENT” on page 9).
4. Always transport the product by its handle.
5. Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
6. Secure the product to prevent it from slipping or falling over.
Fig. 14
2 bolts +
spring washers
Cutting device
(scarifying cylinder)
Fig. 15
Cutting device
(raking cylinder)
Loading ...
Loading ...
Loading ...