Loading ...
Loading ...
Loading ...
7
OUT
This device complies with part 15
of the FCC Rules. Operation is
subject to the following two
conditions:
(1) This device may not cause
harmful interference, and (2) this
device must accept any
interference received, including
interference that may cause
undesired operation.
FCC ID: QKH-KANTOTUK
IC: 10678A-KANTOTUK
ON
OFF
POWER
5V / 2A
100-240V ~ 50/60 Hz
Max Power Consumption 120W
FUSE:T3.15AL 250V
www.kantoaudio.com
Designed in Canada
Made in China
SUB
OUT
OPT
RCA
USB
PHONO
GND
L R L R
Serial Number
IN
Setting up TUK
Ensure that the Power Switch is in the OFF position.
Connect the two speakers together as shown below using the supplied speaker cable. Connect
the RED (+) and BLACK (−) terminals from the active speaker to the corresponding terminals on
the passive speaker. If you wish to place your speakers farther apart than the supplied cable will
reach, we recommend that you purchase a heavier gauge of speaker cable to minimize signal loss.
Follow the instructions on the ensuing pages to connect your audio sources to TUK. The examples
in the following pages are not meant to be exhaustive - just examples.
Connect the AC power cord from TUK’s active speaker to your wall outlet. Turn the Power Switch
to ON once all the inputs have been plugged in.
TUK is designed to perform optimally when positioned at least 8” from the rear wall in an average
listening room. However, it may not be possible to install the speaker in this position and since
rooms vary in shape, size, and furnishing, a certain amount of experimentation is necessary to
determine the most suitable position. Moving the speaker very close to the rear wall will enhance
the bass frequencies but will tend to reduce soundstage depth, while moving the speaker away
from the rear wall will tend to have the opposite eect. Avoid positioning the speaker close to
or in the corner of a room, as this will excite undesirable room coupling in the low and middle
frequencies. Room characteristics and positioning have a profound eect on the performance of
the speakers, so time and eort devoted to achieving the optimum positions will be rewarded.
ATTENTION
When connecting audio cables the Power Switch must be turned OFF. After connecting all cables,
the unit can be turned ON. When the volume is high, this system can produce noise levels that
could permanently damage your hearing. TUK is a self-powered speaker system. Do not connect
the speaker inputs to the outputs of a stereo amplier. Damage may occur. Use only the power
cord provided with TUK.
Loading ...
Loading ...
Loading ...