Loading ...
Loading ...
Loading ...
PROPER AIR CIRCULATION
• To assure your freezer works at the maximum efficiency it was designed for, you should install it
in a location where there is proper air circulation, plumbing and electrical connections.
• The following are recommended clearances around the freezer:
Sides……………4” (102mm)
Back...................4” (102mm)
Top.....................4” (102mm)
WARNING
ELECTRICAL REQUIREMENT - SHOCK HAZARD
ELECTRICAL REQUIREMENT
• Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with proper grounding to
power the freezer.
• Avoid the use of three plug adapters or cutting off the third grounding in order to accommodate a
two plug outlet. This is a dangerous practice since it provides no effective grounding for the freezer
and may result in shock hazard.
4
LEVELLING YOUR FREEZER
• Your freezer has two levelling legs which are located in the front bottom corners of your freezer.
After properly placing your freezer in its final position, you can level your freezer.
• Levelling legs can be adjusted by turning them counterclockwise to raise your freezer or by turning
them clockwise to lower your freezer. The freezer door will close easier when
levelling legs are extended.
DOOR ALIGNMENT
1. Remove the top hinge cover using a flat head screw driver.
Gently lift from the rear of the hinge and slide forward.
2. Loosen the top hinge screws using a Phillips head screwdriver.
3. Adjust the door or put a spacer in between and then tighten the screws.
4. Replace the top hinge cover by aligning the rear of the cover with the rear of the
hinge. Press firmly on the front of the cover until it snaps in place.
Loading ...
Loading ...
Loading ...