Loading ...
Loading ...
Loading ...
Step 12 Completing The Installation
1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you began the installation.
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher is
operating. If no errors occur while it is operating, turn off the dishwasher, and then go to Step
5,6,7 below.
If an error has occurred, turn off the dishwasher, close the water supply valve, and then refer to
the user manual or contact local service center.
Make sure to check for water leakage on both ends of the water supply line and drain hose
connector.
5. Confirm that the kick plate gasket is on the bottom of the kick plate. To install the kick plate with
screw ST3.9*13, refer to the figure 16.
1
2
6. Install the decoration door to the outer door of the dishwasher.
1) Install the hook and brackets on the decoration door, see the figure 17
2) Put the hook into the slot of the outer door, for the positioning, see the figure 18
3) Fix the decoration door onto the outer door by screws and bolts, see the figure 19
<Figure 16>
<Figure 17>
<Figure 18>
<Figure 19>
23
Loading ...
Loading ...