Loading ...
Loading ...
Loading ...
10 | TEMPRA
®
TREND & TEMPRA
®
PLUS WWW.STIEBEL-ELTRON-USA.COM
INSTALLATION
INSTALLATION CONFIGURATION
INSTALLATION
6. Installation configuration
The Tempra can be used for the following applications.
6.1 Typical residential installation
6.2 Typical commercial installation
7. Mounting the unit
!
NOTICE: Unit must be installed in a vertical position
with the water fittings pointing downward.
WARNING: Do not install unit where it would routinely
be splashed with water. Electric shock may result.
CAUTION: Hot water outlet pipes leaving unit can be
hot to the touch. Insulation must be used for hot water
pipes below 36˝ (0.9 m) due to burn risk to children.
!
NOTICE: This unit should not be installed in a location
where it may be exposed to temperatures less than
36 °F (2 °C). If the unit may be subject to freezing tem-
peratures all water must be drained from the unit.
Failure to comply with this instruction voids all war-
ranties.
The unit should be located in an area where water
leakage from the unit or connections will not result in
damage to the area adjacent to the unit. If such a loca-
tion cannot be avoided it is recommended that a drain
pan be installed under the unit.
7.1 Mounting dimensions
A
B
C
D
EF
G
Dimensions
A ⅜ ( 1 0 mm)
B 12½ (318 mm)
C 1 (2 6 mm)
D ¾ ( 2 0 mm)
E 7½ (190 mm)
F 7½ (190 mm)
G
3
/
16
(5 mm)
7.2 Mounting instructions
Install Tempra as close as possible to the main hot water draw-
off points.
f Install Tempra in a frost free area. If frost might occur, re-
move unit before freezing temperatures set in.
f Leave a minimum of 5˝ (120 mm) of clearance on all sides for
servicing.
Loading ...
Loading ...
Loading ...