Loading ...
Loading ...
Loading ...
Page 6
Models D49M30SB • D49M36SB • D49M48SB
5. Extend SUPPORT LEGS and attach to bottom of cabinet with
(2) SCREWS through each leg. Tighten HEX SCREWS.
If cabinet bottom is removed:
Use blocks as spacers between floor and support legs.
SUPPORT LEG
(2) #10 X .500 WOOD SCREWS
HEX
SCREW
6. Extend UPPER SUPPORT BRACKETS and attached to sides
of cabinet with (2) SCREWS through each bracket.
(2)
#10 X .500
WOOD
SCREWS
UPPER
SUPPORT
BRACKET
7. Loosen (4) SCREWS attaching BLOWER SUPPORT LEGS
to FLEX BLOWER. Extend legs and secure them to bottom of
cabinet with a SCREW through each bracket.
FLEX
BLOWER
(4) 1/4-20
X .500
SCREWS
SCREWS
Installations using FLEX BLOWER only:
INSTALL HOUSING INTO
CABINET
1. Remove cooktop.
4. Make sure housing is level.
2. Plug UP BUTTON CABLE from right trim into UPPER
RECEPTACLE at bottom right side of downdraft housing and
connect ground wire to GROUND NUT. Run cable up along side
of housing and TAPE in place near top.
3. Set housing into cabinet / countertop opening as far back as
possible. Make sure up button cable threads through opening
as shown and is not pinched.
TAPE
UP
BUTTON
CABLE
UPPER
RECEPTACLE
GROUND
NUT
Loading ...
Loading ...
Loading ...