Loading ...
Loading ...
Loading ...
6
USING YOUR CLEANER
There are four working modes:
• STANDARD MODE: When you press ON-OFF switch, the cleaner is ready to clean thoroughly with the main motorised
nozzle. [3a]
NOTE:
Standard mode is recommended to clean hard floors.
• CONTINUOUS MODE: To enable continuous mode you can pull switch lever back and it will click into place. To disable
continuous mode you can push the switch lever forward.[3b]
• CARPET MODE: Press the Carpet button to switch between full power with agitator ON and standard setting with agitator
OFF. [3c]
NOTE: Carpet mode is recommended for lifting dirt and debris from carpet pile.
• AUTO MODE: When you remove the nozzle or the tube, the product will automatically adapt to a lower power setting for
above floor cleaning with non-motorised tools.
NOTE: For hard cleaning task, it is recommended to use full power.
NOTE: The product starts in last status with memory function.
IMPORTANT: After each use of your product, please ensure to push the switch lever forward to the unlocked position.
Failure to do so may result in a reduction in battery life or failure.
BRUSH BAR STAUS
The brush bar status LED on the nozzle will remain off when using the product is standard or continuous mode, it will
illuminate WHITE when the product is in Carpet mode and will illuminate red if the safety protection system is activated.
[6b]
BATTERY USAGE
When the battery is discharging in normal use, the battery pack LED is white. When the Battery capacity is lower than
5%, the WHITE LED light will begin to flash. [4] When this happens you should stop cleaning and immediately recharge
your battery. [1] When charging the product, the continuous switch lever must be in the OFF position, it is also possible
to charge the battery pack when released from the product.
NOTE: If you are not going to use the cleaner for a long period of time, please
remove the battery pack from the cleaner to maintain the battery life.
WIPER BLADE ASSEMBLY
To obtain the best crevice and carpet performance, it is recommended to assemble the front and rear wiper blades to the
soleplate of the nozzle.
To do this, open the agitator release flap and remove the soft strip. Then grip one wiper blade, by inserting one end into
the rear slot and slide it in until fully home. Repeat these operations for the second wiper blade and slide it in the front
slot. Lock the agitator release flap. [5]
SAFETY PROTECTION SYSTEM
To ensure the reliability of the product is not affected if used under arduous conditions, the product features an integrated
safety protection system.
NOTE: The Safety protection system will action if the agitator has a blockage or is locked, once actioned the agitator
will stop rotating, the white Led lights on the front of the nozzle will go out [6a] and the WHITE LED light on the top of
the nozzle will turn red. [6b] If this happens, simply switch off your product and clear the agitator obstruction. To resume
cleaning, press the on/off button and the product will restart in normal mode.
ACCESSORIES*
2in1 CREVICE & DUSTING TOOL*, 2in1 LARGE DUSTING & FURNITURE TOOL*, LONG FLEXIBLE CREVICE
TOOL*, MULTI FUNCTION UP TO TOP TOOL* AND MINI TURBO NOZZLE*
The above accessories can be fitted directly into the main body unit or the tube. [7]
NOTE: To remove the nozzle or main body unit from the tube, press the respective release button and pull apart.
RADIATOR TOOL* / DEEP CLEANING BRUSH*
The accessory adaptor* must be fitted when using these 2 accessories. [7]
NOTE: The mini-turbo nozzle is ideal for deep cleaning textile surfaces (i.e. sofas) and pet hair removal. Move it steadily
backwards and forwards. After using, please remove hair / threads collected on the brush with scissors if necessary.
* Certain Models Only
Loading ...
Loading ...