User Manual Schlage FC285 PLY 619 PLY KIN Custom Plymouth Front Entry Handle and Plymouth Knob

Documents for Schlage FC285 PLY 619 PLY KIN

The following documents are available:
User Manual Photos
FC285 PLY 619 PLY KIN photo

User Manual

For FC285 PLY 619 PLY KIN.

*P518-467*
P518-467
m
b
c
d
e
i
j
k
f
g
h
a
l
a. Handle
b. Latch
c. Interior chassis
d. Chassis screws
e. Trim
f. Knob/lever
g. Latch/strike screws
h. Strike
i. Washer
j. Handle bolt
k. Bolt cover
l. Drive-in faceplate
m. Hex wrench (Do not discard!)
1 Check door dimensions.
1a If dimensions do
not match, you may
need to modify
your door.
For further assistance,
call Customer Service
at 1-888-805-9837.
1b Check latch and
bolt length.
Measure the backset
as shown.
2 3/8" (60 mm): no
adjustment is
necessary.
2 3/4" (70 mm): see
the Adjust latch
section.
* May vary from 8 1/4" (210 mm) to 9 3/4" (248 mm) for existing hole.
2 Install the latch.
2a Choose the faceplate.
L
See Change
faceplate.
L
See Change faceplate.
2b Secure with screws.
Bevel must
face door
frame!
Actual Size (2)
2b Use wood block and hammer.
Bevel must face
door frame!
3 Install the strike onto the door frame.
L
Use included strike for best performance.
Actual Size (2)
4 Install the handle.
Push rmly! Then
hold in place.
Adjust post
to t hole.
5 Install the interior chassis.
5a Chassis is spring-loaded. Push
against door and hold in place.
5b Secure with two (2) screws.
L
Make sure chassis is straight!
Hold in
place!
Actual Size (2)
Slot on top
6 Install the handle bolt.
Cover snaps
over washer.
Actual Size
7 Install the interior trim.
click
hook
OR
click
hook
8 Install the interior knob/lever.
8a Push knob/lever rmly into place. 8b Then tighten set screw.
Change levers
1. Loosen set screw, but do not
remove.
2. Pull lever off.
3. Reinstall appropriately. Then tighten set screw.
Adjust latch
For 2 3/4" backset, rotate and pull
latch/bolt out to long setting.
Change faceplate
Remove
faceplate.
Use new
faceplate.
Remove
faceplate.
Remove
backplate.
Push drive-in
faceplate
into place.
2 1/8" (54 mm)
holes
1 5/8" - 2 1/4"
(41mm) - (57mm)
9" (229 mm)*
5 1/2" (140 mm)
Standard
4" (102 mm)
Minimum
Backset
2 3/8" or 2 3/4"
(60mm or 70mm)
3/8" (10 mm)
hole
1" (25 mm) holes
OR
Slot on top
OR
Model FC285, Handleset Installation Instructions
Customer Service
(888) 805-9837 www.schlage.com
Loading ...