Loading ...
Loading ...
Loading ...
8
9. REINSTALL THE HYBRID FILTERS
CAUTION
Remove protective plastic film covering filters before reinstalling them.
Rest rear filters edge on filter springs in the range hood. Tilt up the filters into position.
Make sure filter tabs are securely engaged in range hood front edge slots after
installation.
HO0348
FILTER TABS
11. CARE
HYBRID FILTERS AND BOTTOM PANEL
The hybrid filters and the bottom panel should be cleaned frequently. Use a warm detergent solution.
Remove hybrid filters by pushing them towards the back of hood and rotating downward.
Clean all-metal filters in the diswasher using a non-phophate detergent. Discoloration of the filters may occur if using phosphate detergents,
or as a result of local water conditions — this will not affect filter performance. This discoloration is not covered by the warranty. To minimize
or prevent discoloration, hand wash filters using a mild detergent.
STAINLESS STEEL
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Don’t:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the hood to make
sure no dust sticks to stainless steel surfaces.
WARNING
!
Before servicing or cleaning the unit, switch power off at service panel and lock service panel to prevent power
from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
10. LED LIGHTING
The lighting of this hood is produced by two LED modules (included).
WARNING
!
Do not touch LED modules during or soon after operation. Burns may occur. Cannot be replaced by any other type of light bulb
or LED module.
GLASS PANEL
Hot water with mild soap or glass cleaner is all that is usually needed.
When using mild soap, rinse with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
Avoid when choosing a detergent:
- Any cleaners that contain bleach. They will attack stainless steel.
- Any products containing chloride, fluoride, iodide, bromide. They will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc. They are highly explosive and should never
be used close to a range.
Loading ...
Loading ...
Loading ...