Summit SWC1875BCSS 24" Wide Wine Cellar

User Manual - Page 15

For SWC1875BCSS.

PDF File Manual, 20 pages, Read Online | Download pdf file

SWC1875BCSS photo
Loading ...
Loading ...
Loading ...
15
To initiate Sabbath mode, press the POWER and LIGHT keys at the same time for at least 5 seconds.
The indicator light will flash four times and confirm the Sabbath mode is ON.
Sabbath mode can be exited by repeating the above process. The Sabbath Mode will automatically turn
off after 96 hours.
In the event of a power interruption (power surge, breaker switch, etc.), the unit will remember the
previous temperature settings, and when the power is recovered, the cabinet temperature will return to
the same setting as before the power went off.
TEMPERATURE MEMORY FUNCTION
TEMPERATURE ALARM / DOOR ALARM
The audible alarm sounds if the storage temperature is not cold enough.The temperature display
flashes at the same time.
The cause of the temperature being too high may be:
Warm fresh items were placed inside
Too much warm ambient air flowed in when rearranging and removing food
Power failure for some time
The appliance is faulty
The audible alarm is automatically silenced and the temperature display stops flashing when the
temperature is sufficiently cold again.
If the door has been left open for more than 60 seconds, the alarm will sound. Pressing the POWER
key once will switch off the audible alarm.
Your unit is provided with a lock and key combination.
DOOR LOCK
The keys are located inside the plastic bag that contains the Instruction Manual. Insert the key into the
lock and turn it counter-clockwise to unlock the door. To lock the door, do the reverse operation, making
sure the metal pin is engaged completely. Remove the key and place it in a secure place for safekeeping.
To prevent damaging the door gasket, make sure to have the
door all the way open when pulling the shelves out of the rail
compartment.
WINE SHELVES
For easy access to the stored bottles, you can pull the
shelf approximately halfway out of the rail compartment.
However this unit was designed with a plastic post on each
side of the shelf track to prevent bottles from falling.
When removing the wooden shelf from the inner rails,
make sure to remove all bottles first. Then move the shelf
to the position where the notches in the wooden shelf are exactly aligned with the plastic posts and lift
the wooden shelf. In order to replace the shelf, repeat this procedure in reverse.
DEFROSTING
The unit defrosts automatically in normal operating conditions.
The evaporator behind the rear wall of the unit defrosts automatically. The condensate collects in the
Loading ...
Loading ...
Loading ...