Loading ...
Loading ...
Loading ...
Operating the Stove
This section describes how to activate your Stove using either the remote control or manual controls.
The mains switch (Fig. 3a) controls the electricity supply to the Stove.
Note: The mains switch must be in the on ( I ) position for the Stove to operate either with or without heat.
The switch is located on the front panel behind the door. Open the door to access the switch - see Fig. 3.
When activated the logbed will light up and after approximately 7 seconds the ame picture will appear.
The user may notice a blank screen for approximately 2-3 seconds, every 30 minutes. This is normal and should not be
a cause for concern.
Remote Control :
To activate the remote control, remove the battery clear, plastic strip, which is used to ensure the remote is fully charged
before use - see Fig. 2.
To operate, aim the remote control to the front of the appliance. Press the standby button ( ) on the remote control to
leave the Stove in standby mode - indicted by a red light. Press the standby button to activate ame effect. and /or heat.
The audio volume (spark sound) may be adjusted by pressing the volume control buttons : volume down and
volume up.
Logbed Ambience :
The Stove has an LED that brightens the logbed. For your preference, the brightness can be adjusted by pressing
button to brighten and the button to dim/turn off the LED. An audio ‘beep’ can be heard with each press and will stop
when maximum or minimum is reached. Please note, when the top LED is set to minimum(turned off), the effect of the
rear inner panel disappears.
Heating :
To activate the heating press the heat on button ( ) once for half heat (900W) - indicated by 2 audio ‘beeps’. For full
heat (1800W) press again - indicated by 3 audio ‘beeps’. Eeach press of this button activates half heat or full heat - 2
audio ‘beeps’ for half heat and 3 audio ‘beeps’ for full heat.
To turn the heat off press the heat off button ( ) - indicated by one audio ‘beep’. (The fan continues to run for approximately
10 seconds)
Electronic Thermostat :
The heating is controlled by the electronic thermostat. The default setting is ‘22’ - see Fig. 3b. When the heat is activated,
the heating will turn off, when the thermostat senses the temperature is at ‘22’. The heating will be activated again, when
the thermostat senses that the temperature is less than ‘22’. This gure can be changed by pressing the temperature down
button ( ) to reduce the room temperature (min 15) or the temperature up button ( ) to increase the room temperature
(max 30).
Note : the heating will only operate when the mains switch (Fig. 3a) is in the on (I) position and the room temperature is
lower than the electronic set temperature.
For battery replacment refer to the embossed diagram on the back of the remote control.
NOTE - Use Lithium batteries only - CR2025
Attention should be drawn to the environmental aspects of battery disposal.
Manual Control :
The manual controls are located on the lower front panel behind the door of the stove - see Fig. 2.
The button functions are as remote control, described below;
Standby
Volume down
Volume up
Heat off
Heat on (half/full)
Logbed ambience dim
Logbed ambience brighten
Temperature down
Temperature up
to create the perfect ame effect to suit your environment or in areas where the ambient light levels are normal.
A minimum gap of 60mm, at the back of the product (see
*
Fig.1), should be maintained in order for the electronic
thermostat to have optimum effect.
Loading ...
Loading ...
Loading ...