Loading ...
Loading ...
Loading ...
5
OPERATION
CONTROL PANEL
The control panel is located inside the right door on the front panel.
Main Power
ON/Off
Make sure the POWER switch is OFF. Plug
the power cord into a 110-120 VOLT 15 AMP
grounded outlet only. Flip the main power
switch to the “ON” position to enable all
functions. To turn off, flip main power
switch to the “Off” position.
Flame
Adjustment
To adjust the flame effect, turn the dimmer
dial clockwise or counter clockwise to get
the desired flame intensity. The function will
only operate when the main power switch is
in the “ON” position.
Temperature
Control
The heat output is controlled by the
thermostat control dial. Set the thermostat
control dial by turning it all the way
clockwise initially. When the room reaches
the desired temperature, reduce the setting
by slowly turning the thermostat dial
counter clockwise until the heater clicks and
turns off. The heater will then maintain the
room temperature at the desired level.
NOTICE
When the heat function is used for the first time, a slight odor may
be present. This is normal and should not occur again unless the
heater is not used for an extended period of time.
Loading ...
Loading ...
Loading ...