Loading ...
Loading ...
Loading ...
26 49-2000636 Rev. 1
Problem Possible Cause What To Do
Oven light does not
work
Light bulb is loose or defective. Tighten or replace bulb. See the Maintenance section for
instructions on how to replace the bulb.
Oven will not self-clean The temperature is too high to set a
self-clean operation.
Allow the oven to cool and reset the controls.
Oven controls improperly set. See the Cleaning the Oven section.
Excessive smoking
during clean cycle
Excessive soil or grease. Press the illuminated Cancel pad. Open the windows to
rid the room of smoke. Wait until the door unlocks. Wipe
up the excess soil and reset the clean cycle.
Oven not clean after a
clean cycle
Oven controls improperly set. See the Cleaning the Oven section.
Oven was heavily soiled. Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for a
longer period of time.
Strong “burning” or
“oily” odor emitting
from the vent
This is normal in a new oven and will
disappear in time.
To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Cleaning the Oven section.
This is temporary.
Excessive smoking
during broiling
Food too close to burner element. Lower the rack position of the food.
Oven door will not open
after a clean cycle
The oven door is locked because
the temperature inside the oven
has not dropped below the locking
temperature.
Press the illuminated Cancel pad. Allow the oven to cool
below the locking temperature.
“F— and a number or
letter” are displayed on
LCD screen
You have a function error code. Press the Dismiss pad and the control will reset. Allow
the oven to cool for one hour. Put the oven back into
operation. If the function code repeats, disconnect all
power to the oven for at least 30 seconds and then
reconnect power. If the function error code repeats again,
visit cafeappliances.com/service.
Power outage, clock
resets
Power outage or surge Reset the clock. If the oven was in use, you must reset
any cooking function.
Lock Control feature is
activated
If UNLOCK CONTROLS appears in the display, the range
control is locked. Turn this feature off to use the range.
See Lock Control in the Settings section in this manual.
Burners do not light Plug on range is not completely
inserted in the electrical outlet.
Make sure electrical plug is plugged into a live, properly
grounded outlet.
Gas supply not connected or turned
on.
See the Installation Instructions that came with your range.
A fuse in your home may be blown or
the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
Burner parts not replaced correctly. See the Care and Cleaning of the range section.
Burner slots near the electrode, or the
round lighter port on the oval burner,
may be clogged.
Remove the burners and clean them. Check the electrode
area for burned-on food or grease. See the Care and
Cleaning of the range section.
Food residue on electrode Lightly polish flat tip of electrode with nail file or sandpaper
until shiny.
Troubleshooting tips ... Before you schedule service
TROUBLESHOOTING TIPS
Loading ...
Loading ...
Loading ...