Lock Kit Installation
subzero.com 800.222.7820
page 1 of 1
7028772 REV-B 06/2014
Contents
Qty Description
1 Washer, Anti-Rotation
1 Plate, Catch
1 Screw, #10 x ¾"
2 Screw, #10 x ¾" machine
1 Lock, Door
1 Key
1 Washer, Finish
1 Nut, Extension
1 Cam
3 Spacers
1 Trim, Header
1 Template,
1
/8" Drilling
1 Instructions
Installation
1 For ease of installation, install the lock when the unit is
approximately 6" from being fully installed. For stainless
steel panels, skip to step 3.
2 Use the drilling template provided to drill a
1
∕8" diameter
pilot hole through the back of the panel. Then use a
7
∕8"
(Forstner) bit to drill the lock assembly hole.
3 Insert the lock through the finish washer, anti-rotation
washer (not required for stainless panel) then into the
hole. For custom panels, secure the lock to the panel
using the ½" barrel extension nut. For stainless steel
panels, secure the lock with the ¾" barrel extension nut.
4 Install the cam to the lock using the #10 screw. Verify
the lock turns clockwise (right hinge) or counter clock-
wise (left hinge).
5 Install the catch plate by removing the two top cabinet
hinge screws on the handle side of the unit. Place two
spacers under the catch plate. Use the two #10 x ¾"
machine screws provided to install but do not tighten.
6 Verify the lock for proper operation. If catch plate needs
adjusting, add or remove spacer(s) to achieve proper
alignment, then tighten the hinge screws.
7 To create the opening for the catch plate in the header,
drill four
1
∕8" diameter holes. The four locations are
recessed on the back of the header. Once the four
holes have been drilled, use a utility knife to remove the
remaining material.
8 Install the header and header trim.
TEMPLATE FOR
1
∕
8
" PILOT HOLE
Drilling template
LOCK
FINISH
WASHER
HOLE
ANTI-ROTATION
WASHER
EXTENSION
NUT
CAM
SCREW
Install lock
Install catch plate Install header and trim
