Loading ...
Loading ...
Loading ...
13
3. Turn the powerhead upside down. Install the foam lter
over the lter basket (Fig. 15)
4. Replace the powerhead. Lock the latches on both sides
securely (Fig. 7).
5. With the hose and the preferred nozzle connected, insert
the battery into the battery compartment, and press the
ON ( I ) side on the ON/OFF switch (Fig. 13).
6. After vacuuming is nished, press the OFF ( O ) side of the
ON/OFF switch and remove the battery. Clean the debris
and dust in the tank as described in Maintenance section.
Blowing Mode
The cordless wet/dry vacuum also has blower feature. Follow
the instructions below to use the blower feature.
mWARNING! Always wear safety goggles before using it
as a blower.
mWARNING! Keep children and bystanders away from
the working area.
mWARNING! Wear a dust mask if blowing creates dust
that might be inhaled.
1. Shut o the unit and remove the battery.
2. Disconnect the suction hose from air inlet by pressing the
release button on the connector, and pull the hose out
from the vacuum (Fig. 16).
3. Connect the suction hose to the air outlet on the back of
the powerhead by pressing it securely into the air outlet
(Fig. 17).
4. With the hose and the preferred nozzle connected, insert
the battery into the battery compartment, and press the
ON ( I ) side on the ON/OFF switch (Fig. 13). To stop the
unit, press the OFF ( O ) side of the ON/OFF switch and
remove the battery.
NOTE: During the whole blowing process, keep the air
inlet clear to maintain stable air ow.
General Operation Tips
mWARNING! Do not vacuum drywall dust, replace soot
or ash with the unit. This is very ne dust which will not be
captured by the lter and may cause damage to motor.
mWARNING! The foam lter must be used for wet
vacuuming, and make sure to clean the foam lter after using.
mWARNING! Do not use the cartridge lter and paper
dust bag for wet vacuuming. Do not use the cartridge lter for
sharp material.
• Place the equipment on a level surface that is not heat
sensitive.
• Always use the suction hose. Hold the suction hose at a
distance of approximately 0.4 in. (1 cm) above the material
to be vacuumed.
mWARNING! When vacuuming large quantities of liquids,
do not immerse the nozzle attachment completely in the liquid;
leave a gap at the tip of the nozzle opening to allow air inow.
The machine is tted with a oat valve that stops the suction
action when the collection tank reaches its maximum capacity.
You will notice a decrease in motor speed. When this happens,
turn o the machine, remove the battery, and drain the liquid
into a suitable receptacle or drain.
Fig. 15
Foam lter
Filter basket
Fig. 16
Release button
Suction hose
Fig. 17
Suction hose
Air outlet
Loading ...
Loading ...
Loading ...