Loading ...
Loading ...
Loading ...
Operation
11
The delay can be changed at any time
simply by pressing the button until the
new figure appears on the display.
If there is an interruption to the
electricity supply the time delay will
be lost and so will have to be re-set
when the power is restored.
7. To switch off the buzzer, which
sounds at the end of each cycle, press
the ‘ALARM’ button.
8. The load is dried by tumbling in
thermostatically controlled warm air.
Cool air is used for the last 10 minutes
to reduce creasing and cool the load
ready for handling. During this time
the ‘COOLING’ indicator is lit.
9. When the program is fully completed
the drum will stop rotating. The dial
remains at the position of the selected
program. The ‘COOLING’ indicator
will flash and the buzzer will sound.
10.Open the door and remove the load.
If the load is not removed from the
dryer at the end of the
drying cycle, a
‘creaseguard’ function is activated.
Every 15 minutes the dryer will tumble
the load for 5 seconds and the buzzer
will sound.
This process will be repeated until the
‘creaseguard’ function is cancelled by
opening the door.
11. Clean the filter and empty the water
container after every drying cycle to
ensure maximum dryer efficiency. (See
‘Filter’ and ‘Water Container’ sections.)
12. Clean the condenser after approximately
every 10 drying cycles to ensure
maximum dryer efficiency.
(See ‘Condenser’ section.)
WARNING!
THE DRUM, DOOR AND LOAD
MAY BE VERY HOT.
40001342.qxd 25/05/2004 19:12 Page 11
Loading ...
Loading ...
Loading ...