Loading ...
Loading ...
Loading ...
7
5. Push rmly until the bag clicks into place on the unit body.
NOTE: The collection bag must be attached any time
the unit is being operated. The unit cannot start if the
collection bag is not attached properly.
6. The handle length can be adjusted from 16 inches to
21.5 inches. To adjust the handle length, loosen the handle
lock knob by turning it counterclockwise (Fig. 5).
7. With the handle raised in the operating position, extend to
the desired height. Turn the handle lock knob clockwise to
lock the handle (Fig. 6).
mWARNING! To avoid personal injury, make sure the
handle is locked securely after adjusting the length.
Operation
Working Mode Selection
To switch between the working modes, follow the instructions
below.
1. Make sure the unit is switched o and is unplugged.
2. Vacuum mode and blower mode are indicated on the
mode switch. To select, simply rotate the switch to the
desired mode (Fig. 7).
Starting + Stopping
Do not switch on the blower vac until it has been completely
assembled. Before switching on the unit, always check the
appliance cord and the extension cord for signs of damage.
Use only intact cords.
mWARNING! Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
mWARNING! Before switching on the blower vac, make
sure that it is not in contact with any foreign objects. Keep your
hands and feet a safe distance away from the bottom opening.
Failure to comply with these warnings can result in severe
personal injury.
1. Push a loop of the extension cord through the slot on the
extension cord restraint holder from the opposite side and
loop it around the extension cord restraint holder. Connect
the appliance cord and the extension cord (Fig. 8).
Fig. 4
Foot
Notch
Locking slot
Collection
bag
Handle tab
Fig. 5
Handle lock knob
Fig. 6
Fig. 7
Vacuum mode Blower mode
Loading ...
Loading ...
Loading ...