Loading ...
Loading ...
Loading ...
Step 2: Size the Integrated Panel
Cut the integrated panel to the dimensions shown in the
Integrated Panel Dimensions section. On the top drawer
only, drill the 2 counter-bored holes which are clearance
for screw heads on the face of the top drawer and the lock
hole at the bottom of the top drawer only.
This is also a convenient time to locate and drill the holes
for your handle. Most often the handle is to match that of
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the drawer and cabinet.
After the panel is removed from the drawer, drill the
mounting holes from the front, to the recommended
diameter of the handle manufacturer. Counter bore the
backside of the panel so the screw heads do not interfere
with the surface of the drawer.
.35/.31
(9 mm/7.5 mm)
.50
(12.5)
Remove screws
Clips
Gasket
Step 1: Remove Drawers from unit.
1.
2.
Begin by pulling out the top drawer. Remove screws
securing drawer to slides. Pull drawer forward, lift up
and out to clear clips in rear of drawer. Move drawer
forward about 1" (2.5 cm) and set down on slides. At the
right rear corner of the drawer disconnect the display
wire harness. Remove the drawer from the unit by lifting
up o of the slides. Repeat for bottom drawer but
disregard the harness instructions as there is no wiring
to the bottom drawer.
Remove the drawer divider from the drawer and remove
the gasket from the drawer front. Do this by pulling the
gasket out of the channel that holds it to the drawer
front. This will expose the clearance holes for mounting
the integrated panel.
INTEGRATED PANEL INSTALLATION
12
Loading ...
Loading ...
Loading ...