Waterpik WF-13CD012 Cordless Pearl Water Flosser Rechargeable

Instruction Manual - Page 6

For WF-13CD012. Also, The document are for others Waterpik models: WF-13CD*

PDF File Manual, 22 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
66
I
O
II
I
Insert
Important!
Turn Water Flosser o and charge for 24 hours before rst use. Plug the cord into any standard electrical outlet. Make sure you
push the switch into the OFF (O) position before charging. The unit will not charge if the switch is in the ON (|) position. See “Cleaning
and Troubleshooting Your Waterpik® Water Flosser” for guidance on how to look aer your battery. The Waterpik® Water Flosser will
stay charged for up to 2 weeks depending on use.
Filling the Reservoir
Li ip top on reservoir and ll the reservoir with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. The colored ring will be ush with the end of the knob if the
tip is correctly locked into place.
To remove the tip from the handle, press the tip eject button and pull tip from the handle.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by simply sliding the pressure switch on the handle.
Recommended Technique
Lean low over sink and place the tip in mouth. Aim the tip toward teeth, and turn the unit ON (|).
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briey between teeth.
Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close lips to avoid splashing but allow water to ow freely from
mouth into the sink. Keep unit upright during use for best results.
When Finished
Turn the unit OFF (O). Empty any liquid le in the reservoir. If desired, the reservoir may be removed from the power handle by pulling
the reservoir release latch while sliding the reservoir down towards the base of the unit.
To replace the reservoir on the power handle, simply slide it up towards the top of the unit. The reservoir will snap into place when fully engaged.
Eject
Fill
I
O
II
I
Pressure
Setting
1.
2.
Remove
GETTING STARTED
Loading ...
Loading ...
Loading ...