Loading ...
Loading ...
Loading ...
13
ENGLISH
10b Install the battery cover.
Speaker Hole
DO NOT install screw!
11 Set up the Lock.
1. Open the door if it is not already open.
2. Press the Outside Schlage Button.
3. Enter one of the default access codes into the
lock (see label shown in step 6
on page 5).
4. The lock will perform a setup routine. Wait until
the bolt stops moving before continuing.
»
If the Touchscreen did not light up during this
step, you may have a power problem. Install
fresh batteries and make sure the battery wires
are connected (see step 10a on page 11).
If that does not help, make sure the cable is
connected and is not crimped (see step 9b on
page 10).
12 Test the Lock.
CAUTION
Keep the key with you during
testing to avoid being locked out!
»
For complete information about
programming and light/beep patterns,
see the Manual Programming Guide
and Troubleshooting sections in the User
Guide.
12a Extend the bolt (lock) using the inside thumbturn.
1. Close the door.
2. Rotate the thumbturn toward the door jamb to extend
the bolt.
Was this operation smooth?
Continue to
step 12b.
You may need to adjust your door/
frame. Continue to step 12b for
further testing, or go to answers.
schlage.com and watch the video
Proper Alignment of Door and
Frame for a Smoothly Operating
Lock for adjustment instructions.
NOYES
12b Extend the bolt (lock) using the Touchscreen.
1. Unlock the door using the thumbturn if you have
not already.
2. Take the key and the default access codes with you!
Go outside and close the door.
3. Press the Outside Schlage Button.
4. The bolt should extend.
Alignment is
correct.
You need to adjust your
door/frame. Go to
answers.schlage.com
for adjustment
instructions.
YES
NO
The lock has both a low power and high
power mode. It will try low power rst
and then high power when unsuccessful.
After three times using high power, it will
always use the high power mode instead
of trying twice each time. You may want
to adjust your door/frame to conserve
battery power, but it is not necessary.
YES
NO
Did the bolt extend (is the door locked)?
Did the bolt take two tries to
extend?
Each try sounds like two
cycles.
12c Retract the bolt (unlock) using the Touchscreen.
1. Press the Schlage button.
2. Enter one of the default access codes into the lock.
3. The bolt should retract.
Alignment is
correct.
Use the key to unlock the
door. You need to adjust
your door/frame. Go to
answers.schlage.com
for adjustment
instructions.
YES
NO
Did the bolt retract (is the door unlocked)?
12d If the lock failed to lock or unlock:
1. If the Touchscreen did not light up, you may have a power problem. Install fresh
batteries and make sure the battery connector is connected (see step 10a on page
11). If that does not help, make sure the cable is connected to the Alarm Assembly
and is not crimped (see step 9b on page 10).
2. If the lock had power but you need to adjust your door/frame, please go online to
answers.schlage.com for complete adjustment instructions and videos.
Loading ...
Loading ...
Loading ...